CCIE Wireless (v3.1)
Question No: 111 – (Topic 2)
Which MSS value is appropriate on a Cisco 5508 WLC in an IPV6-only environment?
Question No: 112 – (Topic 2)
Refer the exhibit.
The created dynamic interfaces are bound to an interface group for a specific WLAN profile in a Cisco Wireless LAN Controller. You have noticed duplicated multicast streams on the wireless medium for the given WLAN profile. Which statement is correct?
Global multicast mode, globai 1Pv6 config, and multicast listener discovery snooping have not been enabled. Enable this to avoid duplicate streams.
Global multicast mode and internet group management protocol snooping have not been enabled . To avoid stream enable both .
The controller creates different multicast groups IDs for each multicast address and VLAN and a result the upstream router sends one copy for each VLAN. Enable Multicast VLAN to avoid duplicate streams.
The controller always uses layer 3 multicast group 10 for all layer 3 multicast traffic sent to the access point internet group management protocol snooping should be disabled to avoid duplicate streams.
Question No: 113 – (Topic 2)
Refer to the exhibit. A wireless engineer at ACME Company is troubleshooting a wireless client that is unable to associate to a WLAN. What is likely the cause of the problem?
The AP CAPWAP tunnel is down, and is unable to handle any new connections.
The client is providing a wrong credential for dot1x authentication.
The WPA PSKs do not match.
The client uses WPA, but the AP is advertising only WPA2 support.
A firewall is blocking the ports that are necessary for the AP to join the WLC.
Question No: 114 – (Topic 2)
During the Cisco 5760 WLC high availability active and standby process (elected or re- elected) which factor can determine which Cisco 5760 WLC become active?
The cisco 5760 WLC the highest stack member priority value
the cisco 5760 WLC the highest IP address
the cisco 5760 WLC the lowest stack member priority value.
the cisco 5760 WLC the highest Mac address
Question No: 115 DRAG DROP – (Topic 2)
When you enable QoS in a Cisco Unified Wireless environment, the AP queues packets based on the layer 2 CoS value for each packet. The AP processes and applies QoS policies in a specific order. Drag and drop the QoS statement on the left to the correct order of how the AP processes and applies QoS policies on the right.
Question No: 116 DRAG DROP – (Topic 2)
Question No: 117 – (Topic 2)
Which three steps are required during the intial configuration of a Cisco Converged Access controller so that the access points can join? (Choose three)
The Cisco 5760 controller that acts as a mobility controller can support up to 10000APs.
Ensure that an active license is enabled with the proper AP count.
Ensure that the wireless management interface is correctly configured.
In a Converged Access deployment, the APs must be on the same VLAN as the wireless management interface.
To enable wireless services, the Cisco 3850 switch must run an ipservices or ipbase license.
Network connectivity is not necessary because all the APs connect directly to the Converged Access controller.
Question No: 118 – (Topic 2)
Your customer needs the list of all the guest client that connected to Wi-Fi successfully but have not yet authenticated. The customer decides to create an advanced filter in Cisco Pounder monitor gt;client and user which two conditions should be included in the filter? (Choose two)
PEM state =WebauthReqD
On Network= Yes
Type =Lightweight client
Question No: 119 – (Topic 2)
Refer to the exhibit.
Which AAA attribute is not used by the Cisco WLC running AireOS 8.0 ?
Question No: 120 – (Topic 2)
which topology is a valid and functional convergence access topology? 5760-AIR-CT5760-25-kg
100% Dumps4cert Free Download!
–Download Free Demo:400-351 Demo PDF
100% Dumps4cert Free Guaranteed!
–Download 2017 Dumps4Cert 400-351 Full Exam PDF and VCE
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|