[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-151 Dumps with VCE and PDF Download 91-100

Dumps4Cert 2017 Oct Cisco Official New Released 400-151
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-151.html

CCIE Data Center (v2.0)

Question No: 91

Which three statements about the vTracker feature after it is enabled on the Cisco Nexus 1000v switch are true? (Choose three)

  1. The vTracker feature provides information about the virtual machines that are managed by all Cisco Nexus Switches.

  2. The vTracker feature uses the Link Layer Discovery Protocol.

  3. All vTracker views are valid for a given time only.

  4. The vTracker feature provides information about the virtual network ebvironment.

  5. The VSM and vCenter must be on same subnet.

  6. The VSM must be connected with the vCenter to collect information. Answer: C,D,F

Question No: 92

Refer to the exhibit,

Dumps4Cert 2017 PDF and VCE

which two statements about spanning tree are true? (Choose two)

  1. BPDUs from a vPC are processed on this switch

  2. BPDUs are processed and generated by both peer switches.

  3. This switch cannot generate BPDUs for a vPC.

  4. BPDUs are sent to the peer switch for processing.

  5. BPDUs received on this switch are dropped because of Type 2 inconsistency issues.

  6. This switch generates BPDUs for vPC. Answer: C,D

Question No: 93

Which cisco UCS Director features enables you to view the REST API URL for every report display in cisco UCS Director?

  1. Orchestration features set

  2. REST API Brower

  3. Automation feature set

  4. Report metadata

Answer: D

Question No: 94

Which two statements about end-host mode are true? (Choose two.)

  1. In end-host mode, if a vNIC is hard pinned to an uplink port and this uplink port goes down, the system repms the vMIC, and the vNIC go

  2. End-host mode allows the fabric in interconnect to act as an end host to the network, representing all servers (hosts) connected to it through vNICs.

  3. End-host mode is the default Ethernet switching mode.

  4. In end-host mode, the fabric interconnect runs the 5pann,ng Tree Protocol to avoid loops.

  5. In end-host mode, if a vNIC is hard pinned to an uplink port and this uplink port goes down, the system repins the vNIC but the vNIC remain down until manual intervention.

Answer: B,C

Explanation: Ref: http://www.cisco.com/c/en/us/solutions/collateral/data-center- virtualization/unified-computing/whitepaper_c11-701962.html

Question No: 95 DRAG DROP

Drag and drop the correct port security configuration on the left to the correct action on the right.

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Explanation: Shut Down Protect Errdisable Restrict

Dumps4Cert 2017 PDF and VCE

鈥?/p>

http://www.cisco.com/c/dam/en/us/td/i/templates/blank.gifShutdown-Shuts down the interface that received the packet triggering the violation. The interface is error disabled. This action is the default. After you reenable the interface, it retains its port security configuration, including its secure MAC addresses.

You can use the errdisable global configuration command to configure the device to reenable the interface automatically if a shutdown occurs, or you can manually reenable the interface by entering the shutdown and no shut down interface configuration

commands.

Dumps4Cert 2017 PDF and VCE

鈥?/p>

Dumps4Cert 2017 PDF and VCE

http://www.cisco.com/c/dam/en/us/td/i/templates/blank.gifRestrict-Drops ingress traffic from any nonsecure MAC addresses. The device keeps a count of the number of dropped packets.

鈥?/p>

http://www.cisco.com/c/dam/en/us/td/i/templates/blank.gifProtect-Prevents violations from occurring. Address learning continues until the maximum number of MAC addresses on the interface is reached, after which the device disables learning on the interface and drops all ingress traffic from nonsecure MAC addresses.

Question No: 96

Which three port types support port security in Nexus 7000? (Choose 3)

  1. access ports.

  2. vPC ports

  3. SPAN source ports.

  4. Layer 2 and Layer 3 ports.

  5. SPAN destination ports.

  6. trunk ports.

Answer: A,C,F

Question No: 97

Which two security features are supported by IMX-API? (Choose two.)

  1. All communication the device is encrypted when you use VPN.

  2. All communication to the device is encrypted when you use HTTPS.

  3. NX-API support certificate-based authentication.

  4. Users must have appropriate accounts to access the device through NX-API.

Answer: B,D

Question No: 98

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

The administrator has been provided with this topology, but has not been provided with the IP address of storage switch and has been asked zoning. Which two CLI commands can be used to determine the management addresses of the storage switches? (Choose two)

  1. show npv status

  2. show fcns database

  3. show fcdomain status

  4. show fcdomain domain-list

  5. show fcdomain statistics

  6. show cfs internal ethernet-peer

  7. show cfs peers

  8. show npv internal info

Answer: G,H Explanation: Ref:

http://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_2_x/san- os/configuration/guide/cfs.html

Ref: http://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_1_x/1_0_2/san- os/configuration/guide/MgngStorDevc.html

Question No: 99

How do you manually configure a vNIC MAC address?

  1. Use the mac -address-table static command.

  2. Modify the dynamic vNIC connection policy.

  3. Use the set identity dynamic-mac command.

  4. Modify the adapter policy.

Answer: D

Question No: 100

Which three statements about direct-attached storage are true? (Choose three)

  1. The fabric interconnect must be in Fibre Channel switch mode.

  2. If you connect to Cisco NX-OS on the fabric interconnect, you can see the flogi by using the show flogi database vsan lt;vsan IDgt; Command.

  3. For maintenance of direct attached storage, you must define a maintenance policy.

  4. The fabric interconnect must be end-host mode.

  5. you need not map an FCoE VLAN when creating the storage VSAN.

  6. to configure the zoning, you must create a storage connection policy.

Answer: A,B,F Explanation:

Ref: http://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs- infrastructure-ucs-manager-software/116082-config-ucs-das-00.html

100% Free Download!
Download Free Demo:400-151 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-151 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *