CCIE Data Center (v2.0)
Question No: 51
Which statement about soft pinning is incorrect?
If no uplink Ethernet port channel is configured with all VLANs on the vNIC.Cisco UCS Manager drops the traffic for all of the VLANs on the vNIC.
When the VLAN validation fails, a VLAN mismatch fault with a severity of warning appears.
It is the default behavior Cisco UCS.
Cisco UCS Manager pins the vNIC to an uplink Ethernet port or port channel according to VLAN membership criteria.
Question No: 52
Which two statements about the Cisco Open SDN Controller are true? (Choose 2)
It can be used in multivendor environments.
It is a commercial distribution based on the OpenFlow controller.
The controller is available as an appliance only.
Security is enforced by using the Open Services Gateway Initiative framework.
Your own, new network service functions can be added via Java APls.
Question No: 53
Which three guidelines and limitations of policy-based routing are true? (Choose three.)
An ACL used in a policy-based routing route map cannot include a deny statement.
A policy-based routing route map can have multiple match or set statements per route- map statement.
Policy-based routing and WCCPv2 are not supported on the same interface if bank chaining is disabled.
The same route map can be shared among different interfaces for policy-based routing as long as the interfaces belong to the same VRF instance.
Setting a tunnel interface or an IP address via a tunnel interface as a next hop in a policy-based routing policy is not supported.
A match command can refer to more than one ACL in a route map used for policy-based routing.
Question No: 54
Refer to the exhibit.
Assuming no traffic engineering has been configured, what is the link speed of port channel 200?
Question No: 55
Which two options does ITD replace? (Choose two.)
Layer 7 load balancer
Layer 4 load balancer
Question No: 56
Which statement about the converged network adapter is true?
The converged network adapter is a multifunction adapter that combines the functions of Ethernet NICs and Fibre Channel host bus adapters.
The converged network adapters are compatible only with Cisco UCS.
The converged network adapter is a virtualized multifunction adapter that combines the functions of Ethernet NICs and iSCSI on the same card.
The converged network adapter is a multifunction adapter that works with multiple network speeds and duplex settings, and it supports several storage and network protocols.
Explanation: Ref: http://www.cisco.com/c/en/us/products/collateral/switches/nexus-5000- series-switches/data_sheet_c78-618603.html
Question No: 57
Refer to the exhibit.
Which cause of this error is true?
The upstream switch is in NPV mode.
VSAN mismatch on an uplink.
The upstream switch port is disabled.
No interfaces have been configured as uplinks.
Question No: 58 DRAG DROP
Drag and drop the mode of operation on left onto the correct definition on right.
Power supply and input source redundancy (full redundancy) Combined
Power supply redundancy (N 1)
Input source redundancy (grid redundancy)
Ref: http://www.cisco.com/c/en/us/products/collateral/switches/nexus-7000-series- switches/Data_Sheet_C78-437761.html
Question No: 59 DRAG DROP
An admin is updating an existing Cisco UCS environment to accommodate a new storage array that will be directly attached to the Cisco UCS.
Unmanaged servers external to the Cisco UCS fabric interconnects will also access the new array existing Cisco UCS service profiles will be used to access the new storage array.
Drag and drop the appropriate steps from left into the correct order on the right to migrate the Cisco UCS to support the new storage array.
Explanation: Configure UCS into FC Switching Mode Configure Storage Port on UCS
Configure Zoning on upstream switch Create/Configure LUN Masking on Storage Array The general process to configure DAS in UCS is:
->Configure FI in FC switch mode.
->Create required virtual SAN (VSAN).
->Set the port role in UCS.
->Check if the storage port worldwide port name (WWPN) is logged in to the fabric.
Ref: http://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs- infrastructure-ucs-manager-software/116082-config-ucs-das-00.html
Question No: 60
Refer to the exhibit.
SwitchA and switchB have these zonesets currently active and are connected by an ISL that is configured to transport VSA Enhanced zoning is configured for VSAN, and merge- control is set to restrict. Which statement about this configuration is true?
Enhanced zoning is configured, so the user is prompted on the CLI to permit or deny Zone2 into the active zone set.
Zone merge fails because the currently active zone sets are not identical.
Zone merge succeeds and the resulting zone set matches switchB.
Zone merge fails because merge-control set to restrict, which means that merges are never permitted.
Zone merge succeeds but Zone2 is dropped from the active zone set because it is not currently included in the active zone set in switchA.
100% Dumps4cert Free Download!
–Download Free Demo:400-151 Demo PDF
100% Dumps4cert Free Guaranteed!
–Download 2017 Dumps4Cert 400-151 Full Exam PDF and VCE
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|