[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-101 Dumps with VCE and PDF Download 201-210

Dumps4Cert 2017 Oct Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-101.html

CCIE Routing and Switching (v5.1)

Question No: 201 – (Topic 2)

Which feature can mitigate hung management sessions?

  1. Contr枚l Plane Policing

  2. the service tcp-keepalives-in and service tcp-keepalives-out commands

  3. the servic锚 tcp-small servers command

  4. vty line ACLs

Answer: B

Question No: 202 – (Topic 2)

Which DHCP message type 莽loes the DHCP Server send to a client to confirm its allocated IP address?

  1. DHCPACK

  2. DHCPOFFER

  3. DHCPDISCOVER

  4. DHCPREQUEST

Answer: A

Question No: 203 – (Topic 2)

Which attribute is not part of the BGP extended ecommunity when a PE creates a.VPN- IPv4 route while running OSPF between PE-CE?

  1. MED

  2. OSPF network type

  3. OSPF domain identifier

  4. OSPF route type

  5. OSPF router id

Answer: B

Question No: 204 DRAG DROP – (Topic 2)

Drag and drop each multicast protocol from the left onto the matching description on the right. Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 205 – (Topic 2)

Which statement is true about IGMP?

  1. Multicast source send IGMP messages to their first-hop router, which then generates a PIM join message that is then sent to the RP.

  2. Multicast receivers send IGMP message to signal their interest traffic multicast groups.

  3. IGMP message are encapsulated in PIM register message and send to the RP.

  4. Multicast receivers send IGMP message to their first-hop router, which then forwards the IGMP message to the RP.

Answer: B

Question No: 206 – (Topic 2)

163 QUESTIN TEXT IS NOT AVAILABLEwhich three statements about EIGRP and BFD are true ? (choose three)

  1. BFD is independent of the routing protocol,so it can be used as a generic failure detection mechanism for EIGRP.

  2. Some parts of BFD can be distributed to the data plane,so it can be less CPU-intensive than reduced timers, which exist wholly at the control plane.

  3. Reduced EIGRP timers have an absolut minimum detection timer of 1-2 seconds; BFD can provide sub-second failure detection

  4. BFD is tied to specific routing protocols and can be used for generic fault detection for the OSPF,EIGRP and BGP routing protocol

  5. BFD is dependent on the EIGRP routing protocol,so it can be used as a specific failure detection mechanism

  6. BFD resides on the control plane,so it is less CPU-intensive than if it resided on the date plane

Answer: A,B,C

Question No: 207 – (Topic 2)

How does an IPv6 host automatically gen猫rate a global address?

  1. It prepends its interface identifier to the network prefixs contained in Router Advertisement messages

  2. It appends its interface identifier to the network prefixs contained in Router Advertisement messages

  3. It appends its interface identifier to the network prefixs contained in Router Solicitation

    messag s

  4. It prepends its interface identifier to the network prefixs contained in Router Solicitation messages

Answer: B Explanation: QUESTIO.N 7

Which statement about the feasible distance in EIGRP is true?

  1. It is metric that is support by the best next hop toward the destination

  2. It is the maximum metric that should feasibly be considered for installation in the RIB C.It is the smallest metric toward the destination enc#39;OuntereD… … time the destination went from Active to Passive state

D.It is the maximum metric possible based on the maximum hop count that is allowed Answer: C

Question No: 208 – (Topic 2)

Which two options are benefits of Metro Ethernet?(Choose two.)

  1. It supports CHAP authentication.

  2. It includes a comprehensive framing mechanism.

  3. It integrates seamlessly throughout the enterprise.

  4. It can negate link parameters such as frame speed

  5. It provides lower cost per-port than other WAN technologies

Answer: C,E

Question No: 209 – (Topic 2)

Which option is the default LACP load-balancing algorithm for IP traffic on Layer 3?

  1. the source and destination IP address

  2. the source IP port

  3. the source and destination MAC address

  4. the destination port

  5. the destination IP port

Answer: A

Question No: 210 – (Topic 2)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

If R1 and R2 cannot establish an OSPF neighbor relationshipwhich two action can you take to (Choose two)

  1. Configuration PPP authentication under the R2 Gigabitethemet 0/1 interface

  2. Change the ip local pool command on R2 to ip local pool pooh 192 168 1 2 192 168 15

  3. Configuration R1 to send the username and password on the Dialer 1 interface

  4. Change the PPP authentication to CHAP authentication

  5. Configure PPP encapsulation under the R1 virtual-tempi at interface

Answer: C,E

100% Free Download!
Download Free Demo:400-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *