[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-101 Dumps with VCE and PDF Download 191-200

Dumps4Cert 2017 Oct Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-101.html

CCIE Routing and Switching (v5.1)

Question No: 191 – (Topic 2)

which statement about NAT64 is true?

  1. It uses one-to- one mapping between IPv6 addresses and IPv4 addresses

  2. It re quires static address mapping between 1Pv6 addresses and 1pv4 addresses

  3. It can be used to translate an IPv6 network to another J Pv6 network

  4. It can be configured for stateless and stateful transtation

Answer: D

Question No: 192 DRAG DROP – (Topic 2)

Drag and drop each extended ping IP header option from the left onto quot;the corresponding description on the right

Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 193 – (Topic 2)

n an STP domain. Which two topology are true a nonroot switch, when it reveives a configuration BPDU from the root bridge with the TC bit set? (Choose two)

  1. It does not recalculate the STP topology upon receiving change notification from the root switch.

  2. It sets the MAC table aging time to max_age time.

  3. It recalculates the STP topology upon receiving topology change notification from the root switch.

  4. It sets the MAC table aging time to forward_delay time.

Answer: A,D

Question No: 194 – (Topic 2)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Switch A is connected to two MST domains for the first time. The error is observed on

Switch A %SPANTREE-2-PVSTIM_FAIL: Blocking designated port Fa0/1: Inconsistent superior PVST BPDU received onVLAN 10

How can this error be resolved?

  1. Map VLAN 10 to instance 0 in all MST regions.

  2. Remove the 1ST root form MST Region 2

  3. Configure PVST to allow MST Region 1 to be root for VLAN 10

  4. Map VLAN 10 into an appropriate instance on switch A

Answer: C

Question No: 195 – (Topic 2)

Which two statements about redistribution are true? (Choose two)

  1. When BGP traffic is redistributed into OSPF eBGP and iBGP routes are advertised.

  2. When EIGRP routes on a CE are redistributed through a PE into BGP, the Cost Community POI is set automatically.

  3. When EIGRP traffic is redistributed into BGP, a default metric is required.

  4. When BGP traffic is redistribute into OSPF the metric is set to 1 unless the metric is defined.

  5. iBGP routes automatically redistribute into IGP if the routes are in the routing table.

  6. When OSPF traffic is redistributed into BGP internal and external routes are redistributed.

Answer: B,D

Question No: 196 – (Topic 2)

You are implementing new addressing with EIGRP routing and must secondary address. Which are from the routing tablE.Which action is the most efficient solution to the problem?

  1. Disable split-horizon inside the EIGRP process on the router with the secondary addresses

  2. Use a different routing protocol and redistribute the routes between EIGRP and the new protocol.

  3. Disable split-horizon on the interface with secondary address.

  4. Add additional router interface and move the secondary addresses to the new interface.

Answer: C

Question No: 197 DRAG DROP – (Topic 2)

Drag and drop each NAT64 description from the left onto the corresponding NAT64 type on the right. Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 198 – (Topic 2)

Which measure does IS-IS use to avoid sending traffic with a wrong MTU configuration?

  1. MTU value is communicated in IS-IS Sequence Number PDUs (SNP), and IS-IS adjacency is not established if an MTU mismatch is detected.

  2. IS-IS uses does not protect from MTU mismatch.

  3. IS-IS uses padding of hello packets to full MTU.

  4. IS-IS uses path MTU discovery as specified in RFC 1063.

Answer: C

Question No: 199 – (Topic 2)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which two statements about this configuration are true? (Choose two)

  1. It creates summary routes and injects them into EIGRP

  2. It prevent 172.16.0.0/16 from being distributed into EIGRP

  3. It allows a default route to be distributed into EIGRP

  4. It prevent a default route to being distributed into EIGRP

  5. It allows 172.16.0.0/16 and larger students to be distributed into EIGRP

  6. It allow 172.16.0.0/16 to be distributed into EIGRP

Answer: C,F

Question No: 200 – (Topic 2)

How are the Cisco Express Forwarding table and the FIB related to each other?

  1. Cisco Express Forwarding use a FIB to make IP destination prefix-based switching

    decisions.

  2. The FIB is used to population the Cisco Express Forwarding table.

  3. There can be only FIB but multiple Cisco Express Forwarding tables on IOS devices.

  4. The Cisco Express Forwarding table allows route lookups to be forwarding to be route processor for processing before they are sent to the FIB

Answer: A

100% Free Download!
Download Free Demo:400-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *