[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-101 Dumps with VCE and PDF Download 161-170

Dumps4Cert 2017 Oct Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-101.html

CCIE Routing and Switching (v5.1)

Question No: 161 DRAG DROP – (Topic 2)

Drag and drop each IP traffic plane-packet type from left onto its description on the right Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 162 DRAG DROP – (Topic 2)

Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 163 – (Topic 2)

Which type of ACL can be applied only to Layer 2 ports?

  1. portACLs

  2. standard ACLs

  3. reflexive ACLs

  4. dynamic ACLs

  5. VLANACLs

Answer: A

Question No: 164 DRAG DROP – (Topic 2)

Drag each IS-IS command on the left to its effect on the right.

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 165 – (Topic 2)

Which two protocols are used by the management plane?(Choose two]

  1. OSPF

  2. ISSU

  3. FTP

  4. BGP

  5. Telnet

  6. DTP

Answer: C,E

Question No: 166 – (Topic 2)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

You must complete the configuration on R1 so that a maximum of three links can amp;e used and fragmentation is supported.

You must complete the configuration on R1 so that a maximum of three links can be used and fragmentation is supported.

Which additional configuration accomplishes this task?

  1. interface Multilink19

    ip address 192.168.1.1 255.255.255.0

    ppp multilink

    ppp multilink group 19

    ppp multilink links minimum 1 ppp multilink links maximum 3 ppp multilink interleave

  2. interface Multilink19

    ip address 192.168.1.1 255.255.255.0

    ppp multilink

    ppp multilink group 19

    ppp multilink links maximum 3 ppp multilink fragment delay 20

  3. interface Multilink19

    ip address 192.168.1.1 255.255.255.0

    ppp multilink

    ppp multilink group 19

    ppp multilink links maximum 3 ppp multilink fragment delay 20 ppp multilink interleave

  4. interface Multilink19

ip address 192.168.1.1 255.255.255.252

ppp multilink

ppp multilink group 19

ppp multilink links maximum 3 ppp multilink interleave

Answer: A Explanation:

The “ppp multilink interleave” command is needed to enable link fragmentation and Interleaving (LFI). The Cisco IOS Link Fragmentation and Interleaving (LFI) feature uses Multilink PPP (MLP). MLP provides a method of splitting, recombining, and sequencing datagrams across multiple logical data links. MLP allows packets to be fragmented and the fragments to be sent at the same time over multiple point-to-point links to the same remote address.

ppp multilink links maximum

To limit the maximum number of links that Multilink PPP (MLP) can dial for dynamic

allocation, use the ppp multilink links maximum command in interface configuration mode.

Reference: http://www.cisco.com/c/en/us/td/docs/ios/12_2/qos/configuration/guide/fqos_c/qcflfi.html

Question No: 167 – (Topic 2)

Which two improvements do SIA-Query and SIA-Reply messages add to EIGRP? {Choose two)

  1. Stuck-in-active conditions are solves faster.

  2. They prevent a route from going into the stuck-in-active state.

  3. They help in the localization of the real failure in the network.

  4. The EIGRP adjacency between two neighbors never goes down.

Answer: A,C

Question No: 168 – (Topic 2)

Which command can you enter to configure a Cisco router running OSPF to propagate the static default route 0.0.0.0 0.0.0.0 172.31.15.1 within the OSPF process?

  1. default-information originate

  2. redistribute static subnets

  3. redistribute static metric 1 subnets

  4. redistribute static

Answer: A

Question No: 169 – (Topic 2)

Which three options must be configured when deploying OSPFv3 for authentication? (Choose three)

  1. encryption algorithm

  2. authentication key

  3. IPsec transform-set

  4. authentication method

  5. encryption key

  6. crypto map

  7. IPsec peer

  8. Security parameter index

Answer: B,D,H

Question No: 170 – (Topic 2)

Which two statements about VSS are true? (Choose two.)

  1. It requires physical switches to be collocated.

  2. It is dependent on spanning-tree.

  3. It requires three IP addresses per ULAN.

  4. Each VSS has a single management IP address

  5. It can eliminate the need for HSRP.

Answer: D,E

100% Free Download!
Download Free Demo:400-101 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-101 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *