[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-051 Dumps with VCE and PDF Download 301-310

Dumps4Cert 2017 Oct Cisco Official New Released 400-051
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-051.html

CCIE Collaboration (v1.1)

Question No: 301 – (Topic 1)

Which definition is included in a Cisco UC on UCS TRC?

  1. Required RAID configuration When TRC uses direct attached storage

  2. Configuration of virtual-to-physical network interface mapping

  3. Step-by-step procedures for hardware BIOS, firmware, drivers, and RAID setup

  4. Server model and local components (CPU, RAM, adapters, local storage) by name only. Part numbers are not included because they change over time

  5. Configuration settings and patch recommendations for VMware software

Answer: A

Question No: 302 – (Topic 1)

Tom Lee is an active user in a Cisco Unified CM deployment with fully functional LDAP synchronization and authentication to an Active Directory. Daily resynchronization is set at 11:00 pm. At 8:00 am on March 1st 2014, this user was deleted from the AD.

What will Tom Lee experience when he attempts to log in Extension Mobility at an IP phone and then access his Unified CM User Options page on his PC, at 9:00 am on March 1st 2014?

  1. Extension Mobility will not work, but the User Options page will work.

  2. Extension Mobility and the User Options page will not work.

  3. Extension Mobility will work, but the User Options page will not work.

  4. Extension Mobility and the User Options page will work.

  5. The information provided is insufficient to answer this question.

Answer: C

Question No: 303 – (Topic 1)

Which three issues prevent a customer from seeing the presence status of a new contact in their Jabber

contact list? (Choose three.)

  1. Incoming calling search space on SIP trunk to IMamp;P

  2. IMamp;P incoming ACL blocking inbound status

  3. Subscribe calling search space on SIP trunk to IMamp;P

  4. PC cannot resolve the FQDN of IMamp;P

  5. Owner user ID is not set on device

  6. Primary DN is not set in end user configuration for that user

  7. Subscriber calling search space is not defined on user#39;s phone

Answer: B,C,D Explanation:

No Presence Information After Login Problem

You receive no Presence information after login. Solution

Complete these steps in order to resolve this issue:

->Make sure that the DNS server the PC is pointed to can resolve the fully qualified

name of the CUPS server.

The host entry will not suffice, you must resolve via DNS.

->Check the SUBSCRIBE CSS on the SIP trunk to CUP.

This CSS must include the partitions of the devices you are trying to receive status on.

->The CUP SIP proxy incoming access control list (ACL) is not allowing incoming SIP presence messages to reach the presence engine. As a test, set the incoming ACL to ALL and reset the SIP proxy and presence engine. Log in again to the CUPC and try to reconfigure the incoming ACL properly.

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified- presence/97443-cups-cupc-ts.html

Question No: 304 – (Topic 1)

A queued call has-reached the maximum wait time configured for a Cisco Unified Communications Manager native call queue. Which statement about what happens to this queued call is true??

  1. Calls are handled according to the Not Available Hunt Option settings on the Line Group Configuration page

  2. Calls are handled according to the When Queue Is Full settings on the Hunt Pilot Configuration page.

  3. Calls are handled according to the When Maximum Wait Time Is Met settings on the Hunt Pilot

    Configuration page.

  4. Calls are handled according to the Forward Hunt No Answer settings on the Hunt Pilot configuration page.

  5. Calls are handled according to the When Maximum Wait Time Is Met settings in Cisco Unified Communications Manager Service Parameters.

Answer: C

Question No: 305 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

What happens to the USB e-token after the administrator fails to enter the correct password at the next attempt?

  1. The token is locked for five days, after which the retry counter resets.

  2. The token is locked until unlocked by Cisco TAC.

  3. The token is locked until Cisco CTL Client is uninstalled and reinstalled on the client PC.

  4. The token cannot be used on the same client PC again. It can be used with another Cisco CTL Client on a different PC.

  5. The token is locked forever.

Answer: E

Question No: 306 – (Topic 1)

A voice engineer is trying to configure CUCM to satisfy the following customer codec requirements.

  • All IP phones should use audio codec at less than 10K bandwidth and maintain voice quality

  • The IP phone audio codec selected should be optimized for speech and music

  • The audio codec should be used in outbound SIP early offer signaling Which configuration best satisfy the requirement?

A)

Dumps4Cert 2017 PDF and VCE

B)

Dumps4Cert 2017 PDF and VCE

C)

Dumps4Cert 2017 PDF and VCE

D)

Dumps4Cert 2017 PDF and VCE

  1. Exhibit A

  2. Exhibit B

  3. Exhibit C

  4. Exhibit D

Answer: C

Question No: 307 – (Topic 1)

Which TFTP server address selection option has the highest precedence on Cisco SCCP IP phones using firmware release 8.0(4) or later?

  1. a manually configured alternate TFTP option on the phone

  2. the first Option 150 IP address received from the DHCP server

  3. the first Option 66 dotted decimal IP address received from the DHCP server

  4. the first IPv6 TFTP Server address received from the DHCP server

  5. the value of next-server IP address in the boot-up process

Answer: A

Question No: 308 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which two commands, when configured on a PPP multilink interface allow a fragment size of 160 bytes? (Choose two).

  1. bandwidth 128

  2. ppp multilink fragment-delay 40

  3. ppp multilink fragment-delay 15

  4. bandwidth 384

  5. ppp multilink fragment-delay 10

  6. bandwidth 512

  7. ppp multilink fragment-delay 20

  8. bandwidth 768

Answer: A,E

Question No: 309 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

A collaboration engineer configured MVA for a company using an existing Cisco IOS voice gateway.

When testing inbound calls it is found that they are all failing.

Which two sets of configuration changes fix this problem? (Choose two)

  1. Dial-peer voice 4100 pots Services ccm

    Destination-pattern 4100$

  2. Dial-peer voice 4101 voip Dtmf-relay h245-alphanumeric

    Session target ipv4:172.16.100.50

  3. Dial-peer voice 4101 voip Dtmf-relay h245-alphanumeric

    Session target ipv4:172.16.100.50 Codec g711ulaw

  4. Dial-peer voice 4100 pots service CCM

  5. Dial-peer voice 4100 pots service CCM

    Incoming called-number .T

  6. Dial-peer voice 4101 VOIP Dtmf-relay h245-signal

Session target ipv4:172.16.100.50 Codec g711alaw

Answer: C,E Explanation:

Please note that, current scenario we are talking only inbound calls.Tricky question

http://www.cisco.com/c/en/us/support/docs/unified-communications/unified- communications-manager-callmanager/200457-Configure-the-Mobile-Voice-Access- Featur.html#anc6

Configuration Example

application

service mva http://10.106.103.149:8080/ccmivr/pages/IVRMainpage.vxml

dial-peer voice 5050 pots service mva

incoming called-number 5050

no digit-strip direct-inward-dial

!

dial-peer voice 3001 voip destination-pattern 5050

session target ipv4:10.106.103.149 dtmf-relay h245-alphanumeric codec g711ulaw

no vad

Question No: 310 – (Topic 1)

Which option is a mandatory LDAP attribute for a user to be synchronized to Cisco Unified Communications Manager?

  1. uid

  2. telephone Number

  3. employee Number

  4. sn

  5. mail

Answer: D

100% Free Download!
Download Free Demo:400-051 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-051 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *