[Free] 2017(Oct) Dumps4cert Testinsides Cisco 400-051 Dumps with VCE and PDF Download 291-300

Dumps4Cert 2017 Oct Cisco Official New Released 400-051
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/400-051.html

CCIE Collaboration (v1.1)

Question No: 291 – (Topic 1)

Exhibit:

Dumps4Cert 2017 PDF and VCE

What setting is required to play personal recordings during standard, closed and holiday hours?

  1. Enable standard, alternate and error greetings

  2. Enable holiday, closed and standard greetings

  3. Enable holiday, closed, error and standard greetings

  4. Enable standard and error greetings

  5. Enable holiday, closed, standard, alternate and error greetings

Answer: C

Question No: 292 – (Topic 1)

Refer to Exhibit:

Dumps4Cert 2017 PDF and VCE

Assume there are no classes of service restrictions and all numbers shown are reachable from this Cisco Unified IP 7965 Phone. Which statement about the dialing key strokes that allow the owner of this phone to reach directory number 2000 is true?

  1. Press the last button on the right hand side of the phone screen.

  2. There is no way to speed dial to directory number 2000 because the speed dial entry is not assigned.

  3. Press 7 on the phone keypad, followed by the Dial soft key.

  4. Press 6 on the phone keypad, followed by the Dial soft key.

  5. Press 5 on the phone keypad, followed by the AbbrDial soft key.

Answer: E Explanation:

Configure these settings for the speed-dial numbers that you access with abbreviated dialing. When the user configures up to 99 speed-dial entries, part of the speed-dial entries can get assigned to the speed-dial buttons on the IP phone; the remaining speed-dial entries get used for abbreviated dialing. When a user starts dialing digits, the AbbrDial softkey displays on the phone, and the user can access any speed-dial entry by entering the appropriate index (code) for abbreviated dialing.

Configuration for Dialing 5 on the phone keypad, followed by the AbbrDial softkey.

Dumps4Cert 2017 PDF and VCE

and it showing on the phone page as

Dumps4Cert 2017 PDF and VCE

Implemented and tested

Question No: 293 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

Which three pieces of information can be derived from this sip message? (Choose Three)

  1. The call will have no audio

  2. Only OOB DTMF will be supported

  3. G722 codec will be chosen

  4. The B2BUA uses IP 172.16.100.50

  5. This is a flow-around configuration

  6. The call will last only 30 minutes

Answer: B,D,F

Question No: 294 DRAG DROP – (Topic 1)

An engineer is setting up a proxy TFTP between multiple Cisco communication Manager clusters.

Drag the step from the left to the correct order on the right to properly configure the certificates for the proxy TFTP. Not all options will be used.

Select and Place:

Dumps4Cert 2017 PDF and VCE

Answer:

Dumps4Cert 2017 PDF and VCE

Question No: 295 – (Topic 1)

Which two actions does the Cisco Unified IP phone use the initial Trust list to perform? (Choose two.)

  1. Decrypt secure XML files

  2. Encrypt RTP traffic for ip phones that are not registered to the same call manager cluster

  3. Download background image files

  4. Authenticate their configuration file signature

  5. Talk securely to CAPF which is a prerequisite to support configuration files encryption

Answer: D,E

Question No: 296 – (Topic 1)

A Cisco Unified Cm user is set up with one remote destination profile that has two remote destination numbers: the first destination number is the user#39;s mobile phone in

country A and the second is a mobile phone located in country . All outbound calls are centralized from the gateway at country A. The user reports that inbound calls are properly routed to the mobile phone as long as the user is in country A. But inbound calls are not successfully routed to country B. Which two options could be the cause of this? (Choose two)

  1. The enable mobile connect option must be selected under the user#39;s second remote destination number.

  2. The value of remote destination limits should be chaned to 2 instead of the default value of 4 under the end user page.

  3. The enable mobile voice access option must be selected under the end user page.

  4. The value of maximum wait time for desk pickup should be changed to 20000 instead of the default of D. 10000, under the end user page.

  5. The rerouting calling search space assigned to the user#39;s remote destination profile must have access to international calls.

Answer: A,E

Question No: 297 – (Topic 1)

Which Cisco Unified CM Application user is created by default and used by Cisco Unified CM Extension

Mobility?

  1. CCMAdministrator

  2. EMSysUser

  3. TabSyncSysUser

  4. CCMSysUser

  5. CTIGWUser

Answer: D Explanation:

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/7x/uc7_0/directry.html

Dumps4Cert 2017 PDF and VCE

Question No: 298 – (Topic 1)

Users report that they are unable to control their Cisco 6941 desk phone from their Jabber client, but the Jabber client works as a soft phone. Which two configuration changes allow this? (Choose two)

  1. Assign group “Standard CTI Allow Control of Phones supporting Connected Xfer and Conf” to the user.

  2. Set the End User page to the Primary Extension on the desk phone.

  3. Set the Owner User ID on the desk phone.

  4. Assign group “Standard CTI Enabled User Group” to the user.

  5. Assign group “Standard CTI Allow Control of Phones Supporting Rollover Mode” to the user.

Answer: A,E

Question No: 299 – (Topic 1)

When neither the active or standby Location Bandwidth Manager in the configured LBM group is available, what will the Cisco Call Manager service on a subscriber Cisco Unified

Communications Manager server do to make location CAC decisions?

  1. It will attempt to communicate with the first configured member in the Location Bandwidth Manager hub group.

  2. It will use the Call Treatment When No LBM Available service parameter with the default action to allow calls.

  3. It will use the Call Treatment When No LBM Available service parameter with the default action to reject calls.

  4. It will attempt to communicate with the local LBM service for location CAC decisions.

  5. It will allow all calls until communication is re-established with any configured servers in the LBM group.

Answer: D

Question No: 300 – (Topic 1)

Which two SCCP call states support the Meet Me soft key? (Choose two.)

  1. On Hook

  2. Connected

  3. On Hold

  4. Off Hook

  5. Ring Out

  6. Connected Conference

Answer: A,D

100% Free Download!
Download Free Demo:400-051 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 400-051 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *