[Free] 2017(Oct) Dumps4cert Testinsides Cisco 352-001 Dumps with VCE and PDF Download 21-30

Dumps4Cert 2017 Oct Cisco Official New Released 352-001
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4Cert.com/352-001.html

CCDE鈩?Written Exam

Question No: 21 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

In this BGP design, what is the next hop for 10.1.1.0/24 on R8 and R7?

  1. The next hop for 10.1.1.0/24 on R7 is R8 and the next hop for R8 is R7.

  2. The next hop for 10.1.1.0/24 on R7 is R5 and the next hop for R8 is R6.

  3. The next hop for 10.1.1.0/24 on R7 is R6 and the next hop for R8 is R5.

  4. The next hop for 10.1.1.0/24 on R7 is R3 and the next hop for R8 is R4.

Answer: A

Question No: 22 – (Topic 1)

During a corporate merger, a network designer is asked for a solution that will provide connectivity between the two enterprise networks. The solution must have the ability to support video sessions so that the CEO can message merger activities to the employees. The designer decides to consider multicast as a transport with MSDP to provide redundancy. Which transport feature does the network designer need to apply to the interconnecting firewall to ensure that Source-Active messages between the MSDP peers can be sent in both enterprise networks?

  1. unicast over a UDP connection

  2. multicast over a UDP connection

  3. unicast over a TCP connection

  4. multicast over a TCP connection

Answer: C

Question No: 23 – (Topic 1)

Which three techniques can be used to improve fault isolation in an enterprise network design? (Choose three.)

  1. aggregate routing information on an OSPF ABR

  2. fully meshed distribution layer

  3. Equal-Cost Multipath routing

  4. EIGRP query boundaries

  5. multiple IS-IS flooding domains

  6. tuned Spanning Tree Protocol timers

Answer: A,D,E

Question No: 24 – (Topic 1)

Which mechanism should be added to a network design to identify unidirectional Spanning Tree Protocol failures through BPDU loss?

  1. UDLD

  2. loop guard

  3. BPDU guard?

  4. root guard

Answer: B

Question No: 25 – (Topic 1)

When designing a network, which two security features should be added to the design to protect hosts from potential IPv6 neighbor discovery denial of service attacks at the access layer? (Choose two.)

  1. SEND

  2. RA Guard

  3. IKEv2

  4. IPsec

  5. DMVPNv6

Answer: A,B

Question No: 26 – (Topic 1)

If a network design must support rapid convergence on half-duplex interfaces, which IEEE 802.1w capability should be used?

  1. root guard

  2. proposal-agreement handshake

  3. loop guard

  4. UplinkFast

Answer: B

Question No: 27 – (Topic 1)

What is a design aspect regarding multicast transport for MPLS Layer 3 VPNs using the Rosen Draft implementation?

  1. LDP is the multicast control plane protocol.

  2. Multicast traffic is forwarded over GRE tunnels.

  3. Multicast traffic is forwarded over LDP or RSVP signaled LSPs.

  4. Using the MDT SAFI in BGP ensures that PIM can be disabled in the core.

Answer: B

Question No: 28 – (Topic 1)

You have been hired to redesign a network due to issues with congestion. How will a router function if the QoS mechanism of congestion avoidance is integrated into the existing network design?

  1. the router handles the overflow of traffic by using FIFO

  2. the router handles the possible buildup of congestion by using WRED

  3. the router forces inbound and outbound traffic to stay within a defined profile by using rate limiting

  4. the router separates packets based on certain characteristics by using NBAR

  5. the router marks packets based on certain characteristics by using PBR

Answer: B

Question No: 29 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

You are designing a spanning-tree network for a small campus. Which two of these options would result in a trouble-free spanning-tree network design? (Choose two.)

  1. Convert all ports to trunk ports, prune off the VLANs that you do not require, and minimize the number of blocking ports.

  2. Introduce Layer 3 VLANs (SVIs) and prune off the VLANs that you do not require.

  3. Convert all the ports to trunk and enable BackboneFast.

  4. Convert all the ports to trunk and enable UplinkFast between all the links.

Answer: A,B

Question No: 30 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2017 PDF and VCE

This diagram depicts the design of a small network that will run EIGRP on R1 and R2, and EIGRP Stub on R3. In which two ways will this network be impacted if there is link instability between R1 and R2? (Choose two.)

  1. R1 will have routes in its routing table that originate from R2 and R3.

  2. R3 will have routes in its routing table that originate from R1 and R2.

  3. R2 will have routes in its routing table that originate from R1 and R3.

  4. R3 will be transit for traffic between R1 and R2.

  5. R3 will not be transit for traffic between R1 and R2.

Answer: B,E

100% Free Download!
Download Free Demo:352-001 Demo PDF
100% Pass Guaranteed!
Download 2017 Dumps4Cert 352-001 Full Exam PDF and VCE

Dumps4Cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Dumps4Cert IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *